I wrapped the first one and its just ok. I think this is a two man job, one to pull it tight and another to hit it with a hair dryer and staple it in .. I was reading that after sitting on them for a while and after they heat up a few times from the sun that most of the pleats smooth out. Anyway, next post will be of all the seats done and installed back in the boat.
I wrapped the first one and its just ok. I think this is a two man job, one to pull it tight and another to hit it with a hair dryer and staple it in .. I was reading that after sitting on them for a while and after they heat up a few times from the sun that most of the pleats smooth out. Anyway, next post will be of all the seats done and installed back in the boat. Stainless steel staples I assume?
Thoroughly enjoyed reading this entire thread. Halfway through it I just happened to see a posting date. This was started in March of this year...Beach Farmer, you have done a lot of work in in the past 9 months on your two boats Doing projects like that takes someone special. Good on you !!!!!!!
Got the borescope down in the tank and it's not terrible but there's some junk down there that needs to come out. The only thing that concerns me is that the tank is bone dry. It's been sitting for many years. Here's to hoping that there are no leaks.
Got the borescope down in the tank and it's not terrible but there's some junk down there that needs to come out. The only thing that concerns me is that the tank is bone dry. It's been sitting for many years. Here's to hoping that there are no leaks. Can you plug the lines and pump some air in there? I can send you a water line pressure gauge that our plumbers use to test their lines for close in inspection.
An update! I dont see the little turtle logo.!!!